Skip to Content
Raydo

Raydo phone app

Pair a compatible iPhone or Android phone with Raydo desktop using a connection code.

The Raydo phone app connects directly to Raydo on your computer over the local network. While connected, open an assistant to send a message, see its progress, review a pending confirmation, or open a delivered file when those actions are available in your build.

Compatible Link v2 builds

The pairing steps below require a desktop build with Raydo Link v2 and a compatible phone build. Available actions depend on both builds. Check that pairing and messages work on your devices before using approvals or file handoff for an important task.

Before pairing

  • Use a compatible Raydo phone build. The Raydo Link v2 app targets iOS 26 or later and Android 9 or later. Availability depends on the build distributed to you.
  • Use a desktop build that can show a connection code in Settings → Phone. Keep Raydo open and connect your phone and computer to the same Wi-Fi network.
  • Open the phone app and allow camera access when prompted for scanning. On iPhone, allow Local Network access if prompted so the app can reach your computer.

Pair and check the connection

  1. In Raydo on the computer, open Settings → Phone. The Connection code appears for the first phone. If a phone is already listed, choose Connect another phone. Keep the code private.
  2. In Raydo on the phone, tap Scan code and point the camera at the code on the computer. The desktop prompt may mention iPhone. A compatible Android build also has Scan code.
  3. Wait for the app to connect. Check that the intended phone appears in Your phones on the desktop. On the phone, open an assistant and send a short message to check that the reply comes back.

Reconnect or remove a phone

If the QR code fails, keep Settings → Phone open and scan the current code. If the app cannot reach the computer, check the Wi-Fi network, that Raydo is still open, and the phone's local network permission where applicable. If the device appears under Older app, use a compatible phone build and scan a new code.

To revoke access from the computer, choose Remove next to the phone in Settings → Phone. To disconnect from the phone, open Settings → Computer → Disconnect. Pair again by scanning a new code.

To contact your Personal Assistant in Telegram, WeChat, or iMessage, see Pair a messaging app.

On this page

Raydo phone app